Power Supply & Control Board Repair

Power supply and control board repair, cabinet by cabinet

Blown rails, dried-out capacitors, burnt traces, boards with no schematic in sight — we repair industrial power supplies and custom control boards at component level, then verify every rail before it goes back.

Every board gets a reference, a report and a warranty
24V rail
// rail stable, ripple within spec
How it works

A process built around trust

01 · Reception

Reception & inspection

Your board arrives, gets logged under its own case reference, and goes through a full visual and electrical inspection for burnt or damaged components.

02 · Diagnosis

Diagnosis & quotation

We trace the fault component by component — with or without an original schematic — and send a clear quote. Nothing gets repaired until you approve.

03 · Return

Repair, test & return

Once approved, we repair the board, check every output rail and ship it back with a full report.

What we see

Common power supply and board faults

  • Blown fuses and dead output rails
  • Failed switching transistors or MOSFETs
  • Electrolytic capacitor degradation ("capacitor plague")
  • Burnt traces, connectors or terminal blocks
  • Worn or pitted relay contacts
  • Failed rectifier diodes and bridge rectifiers
  • Component-level faults on custom or unlabeled boards
  • Intermittent faults that appear only under load or heat

Repair happens at component level, and we can often work from the board itself even when no schematic exists — tracing the circuit to find what actually failed.

Coverage

What we work on

  • 24V DC din-rail supplies (Siemens Sitop, Phoenix Contact, Mean Well)
  • Linear and switch-mode power supplies
  • Custom relay and interface boards
  • I/O interface and driver boards
  • Cabinet-level control boards without documentation
  • Legacy and obsolete board designs
What you get

What every board repair includes

Traceability

A unique case reference and a full repair report follow your board from the moment it arrives.

Tested

Every repaired supply or board is functionally tested before it leaves the workshop.

Root-cause insight

When a board keeps failing, we dig into why — heat, load, or a design weak point — and flag it in the report.

Warranty

Repairs are backed by a standard warranty, so you're covered once the board is back in the cabinet.

Decide faster

Repair or replace?

Choose repair when

  • The board is custom, unlabeled, or no longer manufactured
  • You want the root cause found, not just a swapped part
  • You need a traceable repair with a report and warranty
  • A drop-in replacement doesn't actually exist

Consider replacement when

  • A standard, off-the-shelf supply covers the same spec
  • You need uptime now and a matched spare is ready
  • A cabinet upgrade or standardization project is already planned
Before you ship

Get it to us the right way

  • Photograph the board before removal: orientation, connectors and wiring.
  • Label every wire and connector as you disconnect it.
  • Write the case reference on both the board and the box.
  • Describe the fault and what the board powers or controls.
  • Use an anti-static bag and pack it so it can't flex or shift in transit.
On-site option

When the fault only shows up in the cabinet

Some faults only appear under real wiring, grounding, or load conditions a bench test can't reproduce. When that's the case, we can send a technician to you instead.

Get started

Ready to get your cabinet back in service?

Tell us what's broken and we'll take it from there.